MHP

Technical Mirco MHP Pumps are used for Boiler feeding condensate extraction water works irrigation sprinkler installation and for generation for high pressure water. The pumps are horizontal radially split multistage pump with radial impellers. The pumps are available up to 13 stages. The Stages are sealed by O-rings and clamped together by Tie-rods. The pump supports are integrally cast on suction and discharge casings and at the bottom. The standard nozzle orientation is on right side when viewed from suction side and the discharge nozzle is vertically up. The Pump Size available is 65x50. The pump can develop pressures up to 40 Bars and flow rate up to 35 m3/hr. MOC: - Suction , Discharge and Stage Casing : - C.I./WCB Stuffing Box, Diffuser and Impeller : - C. I. Shaft : - C45/EN19/AISI410 Wear Ring : - C.I. / Nickel-C.I. Shaft Sleeves: - CI/Nickel CI/SS410 Balancing Disc, Counter Balancing Disk: - S.S. 410 Special Features: - 1. Standard Flanges as per DIN / ANSI possible 2. Pump Load is absorbed by oil lubricated Roller Bearings on both Ends. 3. The hydraulic thrust is balanced by Balancing device consisting of balancing and counter balancing disk. 4. Cooled stuffing box can also be provided,